Wireless Infrared Motion Sensor
(490-2025A)                Assigning A Zone           Faxback Doc. # 18321

Follow these steps to add the infrared motion sensor to your wireless alarm
system, and assign it to a zone.

1.  Press LEARN on the base.  The LEARN indicator flashes.

2.  Enter your access code on the base's keypad.  The base sounds an 
    ascending tone, the LEARN indicator lights steadily, and the indicator 
    for the next unassigned zone flashes.

3.  Enter the zone number you want to assign the device to.  For example,
    press 01 to assign the device to Zone 1.

    NOTE:  If you do not enter the code within 14 seconds, a tone sounds,
           and the base exits the learn mode.

4.  Press TEST on the motion sensor.  The system stores the sensor's
    settings in the selected zone.  The indicator for the selected zone
    lights steadily and a brief tone sounds to confirm the addition of the
    sensor(when the tone sounds your device has been learned by the base). 
    The indicator for the next unassigned zone flashes.

5.  Press CANCEL on the base to exit the learn mode.

REMOVING A SENSOR

Follow these steps to remove a motion sensor from the system.  When a
sensor is removed, it no longer triggers the alarm.

1.  Press LEARN on the base to enter the learn mode.  Then enter the access
    code.  The base sounds an ascending tone.

2.  Enter the zone number for the device you want to remove.  The 
    corresponding zone indicator flashes.

    NOTE:  If you decide not to remove the device for the zone selected,
           wait approximately 20 seconds for the base to clear the cancel
           function.

3.  Press CANCEL while the zone indicator flashes.  The indicator turns off
    and the device is removed from the system.

4.  Press CANCEL again to exit the learn mode.


(CS 10/24/95)