Passive Infrared Alarm
(490-0320)                 Preparation                Faxback Doc. # 18580

SETTING THE ENTRY DELAY

If you want the alarm to sound immediately when someone enters the covered
area, set ENTRY DELAY to INST (instant).

To have time to directly disarm the alarm when you enter the covered area,
set ENTRY DELAY to DELAY. This gives you a 15 second entry delay before the
alarm sounds.

TESTING THE COVERED AREA

Once you complete the installation, you should test the covered area. We 
recommend you test the alarm once a week.

Before testing, check the following:

    The remote switch is ON (if you connected it), or the jumper is 
    connected to the REMOTE SWITCH terminals (if you did not connect a 
    remote switch).

    Power is supplied to the alarm and the 90 second warm-up time is over.

NOTES:  This procedure verifies only the infrared beam coverage.

        Any external device you might have connected does not turn on.

Follow these steps to test the covered area.

1.  Set ALARM to TEST.

2.  Walk through the area you want to protect and watch the ALARM/BATT 
    TEST indicator. The indicator lights and stays on as long as you 
    continue to move within the zones.

3.  Reposition the alarm if necessary and repeat Step 2.


(JC   11/02/95