Dual Floodlight Infrared Security System
(610-2604)              Operation Settings            Faxback Doc. # 19256

RANGE CONTROL

The RANGE control adjusts the sensitivity of the sensor head to movement.
Make adjustments in small increments and test until you reach the desired
sensitivity.  If pets or other small animals activate the security system,
turn this control towards MIN.

DUSK CONTROL

The DUSK control adjusts the light level for turning on and off the 
security systems in the dusk-to-dawn mode and for turning on and off the
sensor.  For now, set the DUSK control at the index mark.  This is the
correct setting for most applications. You might need to adjust this
control for better dusk-to-dawn operation.  Turn the control toward DARK
if the security system turns on too early.  Turn the control toward LIGHT
if the security system turns on too late.

If you set the control fully clockwise (to LIGHT), the sensor turns on the
security systems when it detects motion all the time (even when it is not
dark).

NOTE:  When you change the setting of this control, or when the light level
       changes, the new change does not take effect until 10 minutes after
       the setting was changed or the light level changed.  If movement is
       detected just after the change was made, the new setting will not
       take effect until 10 minutes after the delay time you set on the
       security system.

If you change the setting and don't want to wait for 10 minutes, you can 
bypass this delay by turning the power off AFTER you change the setting.  
Then turn the power back on and wait for 1 minute.

TIME DELAY CONTROL

The TIME DELAY control sets the length of time the lights stay on after
movement in the covered area has stopped.  You can set this time to 0.1 
minutes (6 seconds), 0.5 minutes (30 seconds), 2 minutes, 5 minutes, 15
minutes or 30 minutes.

THIS UNIT SWITCH

The THIS UNIT switch determines how the floodlights function.  If you set
the switch to SENSOR, the floodlights turn on whenever there is movement
in the covered area.  If you set the switch to DUSK, the floodlights turn
on at dusk and off at dawn.

NOTE:  The setting of the THIS UNIT switch does not affect how plug n' 
       power modules operate.  Their operation is determined by the
       settings of the individual "DUSK" and "SENSOR" switches and they
       can operate independently of the floodlights.  See "Controlling
       Other Lights," Faxback Doc.# 19259.


(CS 12/16/95)