Dual Floodlight Infrared Security System
(610-2604)          Controlling Other Lights          Faxback Doc. # 19259

Your security system can turn on up to eight other lights or appliances
connected to plug `n power modules.  Four of the modules can be activated
when there is movement in the covered area.  The other four modules can
be activated with dusk-to-dawn operation.

1.  Set the module's house code to the same letter as the security system's
    house code.

2.  For sensor operation, set the module's unit code to the security 
    system's start code plus one, two, three, or four.  (For example, if
    your security system's start code is 4, set the module's unit code to
    5, 6, 7, or 8.

3.  For dusk-to-dawn operation, set the module's unit code to the security
    system's start code plus five, six, seven, or eight.  (For example,
    if your security system's start code is 4, set the module's unit code
    to 9, 10, 11, or 12.)

4.  For those modules you are controlling with the security system, set the
    corresponding SENSOR or DUSK switches to IN.

5.  Install the modules according to their instructions.

Be sure to turn off the power at the main circuit breaker panel or fuse box
before installing wall switch modules or wall outlet modules,

NOTE:  When you first install a plug 'n power module it might already be 
       on.  If you don't have a plug 'n power controller to turn it off
       with, and you have set the module for dusk-to-dawn operation, you
       might have to wait until the next day for the module to turn off.
       See "Troubleshooting," Faxback Doc.#    , for an alternate method 
       of turning the module off. 

            SENSOR switch Modules set       DUSK switch Modules set
         S  to these numbers turn on        to these numbers turn on
         T  when motion is detected.        at dusk and off at dawn.
         A  _________________________________________________________                                                                        
         R  Add the SENSOR switch           Add the DUSK switch
         T  number to the start code        number to the start code
            number to determine the         number to determine the
         C  module unit code.               module unit code.
         O  _________________________________________________________                                
         D     START CODE+                     START CODE+
         E     +1 +2 +3 +4                     +1 +2 +3 +4             
       ______________________________________________________________
         1     2  3  4  5                       6  7  8  9
         2     3  4  5  6                       7  8  9  10
         3     4  5  6  7                       8  9  10 11
         4     5  6  7  8                       9  10 11 12
       ______________________________________________________________
         5     6  7  8  9                       10 11 12 13
         6     7  8  9 10                       11 12 13 14
         7     8  9 10 11                       12 13 14 15
         8     9 10 11 12                       13 14 15 16
       ______________________________________________________________
         9    10 11 12 13                       14 15 16  1
        10    11 12 13 14                       15 16  1  2
        11    12 13 14 15                       16  1  2  3
        12    13 14 15 16                        1  2  3  4  
       ______________________________________________________________
        13    14 15 16  1                        2  3  4  5
        14    15 16  1  2                        3  4  5  6
        15    16  1  2  3                        4  5  6  7
        16     1  2  3  4                        5  6  7  8
       ______________________________________________________________


(CS 12/27/95)