Dual Floodlight Infrared Security System
(610-2604)                 Troubleshooting            Faxback Doc. # 19261

IF THE FLOODLIGHTS DO NOT TURN ON.

Be sure that the security system has power.  Check that the wall switch
(if installed) is turned on.

Confirm the position of the THIS UNIT switch.

Check the setting of the DUSK control.

NOTE:  If you change the DUSK control's setting you must wait 10 minutes
       for the new setting to take effect.

IF A PARTICULAR MODULE CONTROLLED BY YOUR SECURITY SYSTEM DOES NOT TURN
ON OR OFF.

    Be sure that the module has power and the switch on the light or
    appliance is ON.

    Confirm that the house code on the security system and the module are
    set the same.

    Check the setting of the module's unit code.

    Be sure the SENSOR or DUSK switch for that module is set to IN.

    Try plugging the module into another outlet.  If the module does not
    work in any outlet, replace the module.  If the module works in some
    outlets but not in others, contact your local Radio Shack store for
    help.

IF YOUR SECURITY SYSTEM DOES NOT CONTROL ANY MODULES.

    Be sure there is power to the security system.  If it is controlled by
    a wall switch, check that the wall switch is turned on.  Check that the
    house code is set correctly.

INTERCOM SYSTEMS

Intercom systems that send signals over your house's electrical wiring can
interfere with your plug `n power modules operation.  If the intercom
system has its own separate wiring it does not cause a problem.

POWER INTERRUPTIONS

When the power comes back on after a power failure, your security system
returns to the state it was in before the power loss.  Lamp and wall
switch modules remain off after power is restored.  Appliance modules
stay as they were before the interruption.

If a module is on when you apply power to the security system, the module
will remain on until the security system turns it off.  If you have set the
module for dusk-to-dawn operation and you don't have a controller to turn
it off with, you might have to wait until the next day for the security
system to turn the module off.  Or, you can temporarily set the module to
be controlled by one of the codes used when the security system detects
motion.  Then, walk past the security system.  The module will turn off
after the delay time set on the security system.  You can then set the
module back to the code used for dusk-to-dawn operation.

IF YOU CAN'T GET THE SECURITY SYSTEMS TO TURN OFF.

1.  Turn off power at the circuit breaker panel.  Wait 10 seconds.

2.  Set the RANGE control to MAX.

3.  Set the DUSK control to LIGHT.

4.  Set the TIME DELAY to 0.1 minutes.

5.  Set THIS UNIT switch to SENSOR.

6.  Turn power back on at circuit breaker.

7.  Wait for 1 minutes.  Then walk past the security system, from side to
    side.  The floodlights will be on because they were on when you turned
    the power off.

8.  Ensure that the security system does not detect any movement for at
    least 10 seconds.  The floodlights will then turn off.

9.  Set the controls to your desired settings.


(CS 12/27/95)