Plug'n Power Maxi Controller
(610-2672)                 Installation               Faxback Doc. # 19281

1.  To install your Maxi Controller, simply plug the power cord into any
    functioning 120V outlet.

2.  Using a small screwdriver, choose one of the 16 letters on the Maxi
    Controller's Housecode dial.  All Plug'N Power/X-10 Modules have a 
    similar red Housecode dial.  Set the Maxi Controller and "all the 
    Modules to be controlled by it" to the same Housecode letter.

Having 16 choices for the Housecode enables you to set up several
independent systems in one home without interaction among them.  Also, you
can avoid interference with, or from, a neighbor's system by choosing a
different Housecode letter.

Install and set up the Modules (sold separately)

1.  Install and set up all of your Plug'N Power Modules referring to the 
    instructions included with them.  Be sure to turn off the power at the
    circuit breaker panel when installing Wall Switch Modules.

2.  Set all of your Modules to the same Housecode as you set on the Mini
    Controller.

3.  Set each Module to a Unit Code between 1 and 4 (or between 5 and 8 if
    you set the Selector Switch on the Mini Controller to 5-8).


(CS 1/11/96)