Lamp Module
(610-2682)                 Installation               Faxback Doc. # 19288

Microprocessor wireless remote control system lets you control your lights 
from off to full brilliance.

Override feature lets you turn lamp on and off directly, without using the
control center.

MAXIMUM RATINGS: 300 Watts 120V AC 60 Hz

CAUTION:  For incandescent lamps only!  Do not use this dimmer with any
          appliance or motor.  Do not exceed ratings.

HOUSE CODE

16 different codes match dimmer to control center - lets you use more then
one control center without interaction.

UNIT CODE

Assign command of dimmer to any of the 16 different keys on the control
center for individual on/off control.

INSTRUCTIONS

1.  Match house code letter on red dial with dial setting on control 
    center. (Use a dime or a small screwdriver to set the red Housecode
    dial on the Lamp Module.)If more than one control center is used, each 
    should have a different code letter to avoid interference with each 
    other.

2.  Black dial assigns desired key number on the control center to this
    dimmer location.  If, for example, you want key number 1 command this    
    dimmer, set dial to 1.  More than one dimmer can be assigned to the 
    same key number, allowing one key to control an entire room.

3.  Plug lamp to be controlled into dimmer.  The lamp must be an 
    incandescent type of no more than 300 watts. Check that the lamp 
    switch is in the ON position.  Plug remote dimmer unit into 120V AC 
    wall outlet.

NOTE:  The lamp will be OFF at this time.

It's easy to take control.  Simply plug a controller and modules into
standard 120-volt household wall outlets. (no special wiring needed.)
You can custom design the control system you want.


(CS 1/17/96)