3-Prong Universal Appliance Switch
(610-2684A)                Installation               Faxback Doc. # 19295

UNIT CODE

Assign command of switch to any of the 16 different keys on the control
center for individual on/off control.

HOUSE CODE

16 different codes match switch to control center - lets you use more than
one control center without interaction.

It's easy to take control.  Simply plug a controller and modules into
standard 120-volt household wall outlets. (No special wiring needed.)  You
can custom design the control system you want.

INSTRUCTIONS

1.  Match house code letter on red dial with dial setting on control 
    center. If more than one control center is used, each should have a
    different code letter to avoid interference with each other.

2.  Black dial assigns desired key number on the control center to this
    switch location.  If, for example, you want key number 16 to command
    this switch, set dial to 16.  More than one switch can be assigned
    to the same key number, allowing one key to control several switches.

3.  Plug device to be controlled into switch.  If the plug is polarized,
    it will only fit one way.  Wide blade must be on left side of switch
    receptacle.  Do not exceed the switch's ratings.  Plug switch only
    into a properly grounded 3-wire wall outlet.


(CS 1/18/96)