PG-80 8-Channel Digital Paging System
(490-0710)                  Operation                 Faxback Doc. # 19432

Identification Coding

Before your PG-80 system is ready for use, you must program it with the
identification code and paging numbers.  The identification code becomes
unique to your system and ensures that the receivers will ignore all other
signals.

1.  Check if the STORE indicator on the transmitter is blinking.  The
    blinking of the STORE indicator means that no identification code is
    in the transmitter's memory.

2.  If the STORE indicator is not blinking, press the RESET switch on the
    back with the tip of a ballpoint pen.  The STORE indicator on the
    transmitter wil go out after it has stored the code number.

3.  Enter the four-digit identification code by pressing the number keys
    on the transmitter.  Your code can be any four-digit sequence or a
    combination of numbers between 1 and 8.  Press each button slowly and
    firmly to ensure proper entry.  If pressed too rapidly, the code may
    be entered incorrectly.

4.  The STORE indicator will go out.  The STORE indicator goes out when
    the identification code is entered in memory. Example:  To input the
    identification code sequence, 1, 2, 3, 4:  If the STORE indicator
    blinks, press 1-2-3-4.  If the STORE indicator does not blink, first
    press RESET and then press 1-2-3-4.  If you made a mistake entering
    the code or want to change the code, press RESET.  The STORE
    indicator will start blinking which shows the previous code has been
    cleared from memory.  Follow steps 1 through 4 to enter the new code
    numbers.

5.  Apply one of the self-adhesive number labels to each receiver.  Be
    sure the batteries are installed properly and the receiver's power
    switch is set to READY.

6.  Remove the battery compartment cover of the receiver to gain access
    to the code input jack.

7.  Connect the short patch cord (supplied) to the code input jack on the
    receiver.  The CALL indicator will start blinking when the patch cord
    is connected to the receiver.

8.  Connect the other end ofthe patch cord to the CODE OUT jack on the
    transmitter.

9.  Press the STORE button on the transmitter.  The STORE indicator will
    light which shows that the transmitter is ready to transfer the
    identification code to the receiver..

10. Press the number button on the transmitter that matches the paging
    number label you put on the receiver in Step 5.  Example:  Press number
    button 1 of the transmitter to transfer the identification code and the
    paging number to receiver number 1.  To assign the number 3 to the
    receiver:  Affix the 3 to the receiver.  Connect the patch cord.  Press
    the STORE button.  Press the 3 button on the transmitter.  Confirm the
    indicators/beeper operations.  The PAGING indicator on the transmitter
    will blink when the code and the paging number are being sent to the
    receiver.  The STORE indicator on the transmitter will go off to show
    that the transfer has been completed.  The beeper of the receiver will
    signal four times and the CALL indicator goes off after two blinks to
    indicate that the receiver has accepted the code and paging number from
    the transmitter.  If these do not take place, repeat the steps above.

11. Remove the patch cord from the transmitter and receiver.  Proceed to
    SYSTEM TEST.