Wireless Home Security System
(490-2551)                 Features                   Faxback Doc. # 19503

You can install your Radio Shack Wireless Home Security System with
Emergency Phone Dialer anywhere in your house using the existing house
wiring.  The system operates using radio frequencies, thus eliminating the
need for additional wiring.  It includes a handheld remote, one keychain 
remote, two wireless sensor transmitters, a motion detector, and a lamp 
module so you can immediately begin using your system.  The console can 
monitor up to 16 security zones (with additional remote sensors) and sound 
its built-in alarm when a violation occurs in any zone.

Here are some of the features of your system.

Two Wireless Sensor Transmitters - trigger the console's built-in alarm
                                   when a secured door or window opens 
                                   (additional sensors, Cat. No. 49-2585).

                 Handheld Remote - lets you arm and disarm the system and 
                                   control the lights connected to Plug'n 
                                   Power modules (additional handheld 
                                   remotes, Cat. No. 49-2551T).

                 Keychain Remote - lets you conveniently arm and disarm the
                                   system as you come and go and turn
                                   on/off lights and appliances (additional
                                   keychain remotes, Cat. No. 49-2591).

                     Lamp Module - lets you turn on/off a lamp using a 
                                   remote control.  The lamp also flashes 
                                   on and off during an alarm (additional 
                                   lamp modules, Cat. No. 61-2682).

                 Motion Detector - protects an area where an intruder might
                                   enter (additional motion detectors, Cat. 
                                   No. 49-2589).

  Plug'n Power Compatible Design - lets you add a total of 16 wireless 
                                   sensor transmitters, lamp modules,
                                   motion detectors, and other accessories
                                   to customize your home security system.

            Supervised Operation - keeps track of each wireless sensor 
                                   transmitter's status and alerts you if 
                                   there is a problem (such as an intrusion
                                   or a low battery).

 Built-In Telephone Voice Dialer - dials a friend or neighbor and plays
                                   back your recorded message.

NOTES:  In addition to the parts provided, you need one 9V alkaline battery
        (such as Radio Shack Cat. No. 23-553) to operate the console; six
        AAA alkaline batteries )such as Cat. No. 23-558) - two to operate
        the keychain remote control and four to operate the handheld remote
        control; and eight AA alkaline batteries (such as Cat. No. 23-552)
        - two in each wireless sensor transmitter and four to operate the
        motion detector.

        The suitability of this system to perform as a burglar alarm system
        or as an emergency service device has not been evaluated by
        Underwriters Laboratories, Inc. 

        The wireless sensor transmitters are supplied with NC (Normally
        Closed) magnetic switches.

        You cannot use NO (Normally Open) magnetic switches with this
        sensor.


(JC  1/19/96)