Keychain-Remote Light/Appliance Switch
(610-2663)                 Installation               Faxback Doc. # 19537

Wireless Installation Instructions

1.  Using a small screwdriver, set the house code dial on both the
    transceiver and remote to the same letter.  The remote's house code
    dial is inside its battery compartment.

2.  Set the slide switch inside the remote's battery compartment to 
    correspond to the lamps or appliances you want to control (1 and 2 - or
    5 and 6).  Set unit codes on the lamp/appliance modules to correspond 
    to the slide switch settings.

    NOTE:  Regardless of the slide switch setting.  the transceiver always
           responds to the first remote button.  Use Button 2 to control
           other modules set to unit codes 2 or 6.

3.  Place 2 AAA alkaline batteries (such as Radio Shack Cat. No. 230-0555)
    in the remote's battery compartment as indicated by the polarity 
    symbols (+and-) marked in the compartment.

4.  Fully extend the transceiver's antenna and plug it into any AC outlet.
    Plug the lamp or appliance into the transceiver.  If attaching the 
    transceiver to a switched outlet, turn the switch's power on.


(CS 1/11/96)