Plug' Power Sounder/Actuator Module
(610-2688)                 Installation               Faxback Doc. # 19560

SETTING UP THE MODULE

1.  Use a screwdriver to set the red "house code" dial to the same letter
    as you set on your controller.

2.  Set the black "unit code" dial to a number between 1 and 16.

3.  Set the "Momentary/Continuous" slide switch to the left for momentary
    operation or to the right for continuous operation.

4.  Set the other slide switch to the left to use the module as an 
    annunciator.  Set the switch to the right to use it as an isolated
    contact relay.  Set the switch to the middle position to operate as
    both.

5.  Using low voltage wire, connect the terminals on the module to the unit
    you wish it to operate.

    WARNING:  You can use the module to control something which is
              triggered by a contact closure or you can switch a low
              voltage "through" the contacts of the module.  However, the
              terminals are exposed, therefore for safety, you should not
              connect voltages higher than 30V RMS to these terminals.  If
              you connect voltages higher than this to the terminals, a
              shock hazard might exist.

6.  Plug the module into a standard 120V AC wall outlet.

7.  Test the desired mode of operation by pressing and releasing on ON
    button.

8.  When set for continuous operation, turn off the module by pressing the
    OFF button.

9.  When set for momentary operation, the Universal Module can be turned on
    remotely, by pressing the ON key on any Plug'N Power/X-10 Controller   
    corresponding to the Unit Code you set on the Universal Module.  The 
    contacts will close for between 1.5 and 2.5 seconds every time an ON 
    code is received. If the continuous operation is selected, you can turn
    the module off by pressing the OFF key on any Plug'N Power/X-10 
    Controller.  The module responds to All Units Off but does not respond 
    to All Lights On.


(CS 1/10/96)