Sundowner Controller
(610-2616 CMC)             Operation                  Faxback Doc. # 19616

To turn a light or appliance ON or OFF.

    Press and release the TOP (for ON) or BOTTOM (for OFF) of one of the 4
    number keys corresponding to the Unit Code set on the Module to be
    controlled.

To Dim or Brighten lights.

    Press and release the TOP of the number key for the Lamp or Wall Switch
    Module you wish to Dim or Brighten (doesn't affect Appliance Modules).
    Then press the BOTTOM of the Dim/Bright key to Dim or the TOP of the
    Dim/Bright key to Brighten the light.  Hold the key pressed until the
    desired brightness level is reached.

To turn All Lights On.

    Press the TOP of the All Lights On/All Units Off key to instantly turn 
    on All lights connected to Lamp Modules and Wall Switch Modules (which
    are set to the same Housecode as the SUNDOWNER).  This key does not
    affect Appliance Modules.

To turn All Lights and appliances Off.

    Press the BOTTOM of the All Lights On/All Units Off key to instantly
    turn off ALL Modules (which are set to the same Housecode as the
    SUNDOWNER), including Appliance Modules.

    The Finder Label is a convenient place to indicate the locations of
    lights and appliances controlled.  There is one box for each key.

AUTOMATIC LIGHT CONTROL

Set the switches on the underside of the SUNDOWNER to "ON" if you want
Modules (set to those Unit Codes) to go on at dusk and off at dawn - 
Automatically.  Place the SUNDOWNER near a window so that it faces a bright
source of natural light.  This is important - lights may turn off much 
later than desired at dawn if the lens on the front of the SUNDOWNER is not
"facing" a bright source of natural light.  Set the Sensitivity Control
fully clockwise.  To test the Dusk-to-Dawn operation: Cover up the front
of the SUNDOWNER with your hand.  The lights you have selected should turn
on.  Remove your hand and the lights should turn off again.

NOTE:  If you cover up the front of the SUNDOWNER with your hand when you
       press the buttons during normal operation, you may inadvertently
       cause it to think it is dusk (and turn lights on automatically).

MANUAL CONTROL

Lights and appliances connected to plug-in Modules can be turned ON with
their own power switch.  Simply turn the switch OFF then ON again once or
twice.  For lamps with three-way bulbs, you will have to rotate the power
switch up to 4 times before the light comes on.

The Wall Switch Module can be turned ON or OFF locally using it's push
button.  The power On-Off switch on the Wall Switch Module is used to
completely turn off the power.  For example, when changing a light bulb.


(CS 1/15/96)