Sundowner Controller
(610-2616 CMC)             Safety Precautions         Faxback Doc. # 19618

Don't exceed the ratings of the Modules, these are:

Lamp Module (610-2682) - 300 watts max. incandescent only.

Lamp Module (610-6291  - for fluorescent lighting, switch-controlled
             CMC)        appliances, or high-wattage incandescent lighting
                         where dimming not required.  15 Amp. 

Wall Switch Module (610-6376)- 500 watts max. 60 watts min. incandescent
                               only.

Wall Switch Module (610-6375 -  can be mounted at a fluorescent fixture
                    CMC)        by means of adhesive strips.  4Amp.

Appliance Module (610-2681)- for appliances rated 15 Amp. resistive           
                             (such as coffee pots) or 1/3 H.P. motor       
                             load, or 400 watts for TV sets or 500
                             watts for lamps, because of the "inrush
                             current" from a cold lamp.

NOTE:  Don't use appliance modules for "instant-on" TVs, heavy duty heating
       appliances or anything which would be dangerous if it turned on
       remotely while unattended, an electric fan with poorly protected
       blades for example.

220V Heavy Duty Appliance Module (610-2668) - plugs into a regular 22V 15A
                                              or 20A outlet and will 
                                              control any 220V appliance 
                                              rated at 15A or less.

220V Heavy Duty Appliance Module (610-2669) - plugs into a regular 220V 20A
                                              outlet and will control any
                                              220V appliance rated at 20A
                                              or less.

Wall Switch and Lamp Module - For safety: Don't use with fluorescent, 
(610-2683 and 610-2682)       Mercury, Sodium or Low Voltage lights.  Use 
                              for incandescent lights only.  NO 
                              appliances such as fans etc.  Don't use to
                              control a lamp or fixture which already has a        
                              dimmer on it.  Don't use a Wall Switch Module
                              to control an outlet unless you are sure no 
                              one will plug an appliance into the outlet. 
                              This could damage the Wall Switch Module 
                              and/or the appliance and could cause a safety
                              hazard.

                              The 610-2683 Wall Switch is rated for     
                              incandescent lights up to 300 watts max and 
                              60 watts min.  The 610-2682 lamp module is 
                              rated for incandescent lights up to 500
                              watts max. Both units respond to "All Lights
                              On" and "All Units Off." 


(CS 1/15/96)