Wireless Remote Control Center
(610-2676B)                Troubleshooting            Faxback Doc. # 19623

1.  If the remote control does not turn the control center module on or 
    off:

    Check that the red light on the remote control comes on when you press
    a button.  Replace the batteries if necessary (4 AAA alkaline).  Check
    that the house code dials and selector switches (1-8 or 9-16) on the
    control center module and the remote control are set correctly.  Check
    that you have power to the outlet and the switch on the light or
    appliance is on.

2.  If the control center module won't turn on or off from another type
    of plug'n power controller:

    Try plugging the control center module and the other plug'n power 
    controller into the same outlet.  If the control center module doesn't
    work in ANY outlet, even when it is connected to the same duplex outlet
    (top and bottom) as the controller, replace the control center module. 
    If it works in some outlets but not in others, contact your nearest
    Radio Shack store for help.

3.  If you can't control other plug'n power modules from your remote 
    control:

Try controlling the modules from another plug'n power controller if you
have one, with the controller and module in the same receptacle (see 2.
above).  If the only controller you own is the control center module (this
module is a transmitter as well as a receiver) use an extension cord in
order to plug the control center module and your other plug'n power module
into the same receptacle.  If the module doesn't work in the same 
receptacle as the controller, replace the module.

INTERCOM SYSTEMS

Intercom systems which send voice signals over existing electrical wiring
may interfere with the ability to control other modules from your control
center when the intercom is in use.  If the intercom system has its own
separate wiring, it will not cause a problem.  Intercoms will NOT interfere
with the ability to control the control center from the remote control.

POWER INTERRUPTIONS

When the power is restored after an outage, Lamp Modules and Wall Switch
Modules will normally be OFF.  You can use the remote control to turn
Lamp and Wall Switch modules on after a power failure.  Appliance modules
(including the control center module) have a "latching relay mechanism"
and will stay as they were before the interruption.


(CS 1/11/96)