Remote Control Talking Alarm System
(490-0740)                 Preparation                Faxback Doc. # 31175

This alarm system includes a main control center, two key-chain remote
transmitters, LED indicator, extension wire, and mounting hardware.  Before
you install the system, read the entire installation section and decide
where to mount the control center and route all wiring.  Be sure all wires
can reach their connection locations.

The control center mounts in the engine compartment.  The wiring harness'
three wires connect the control center to the vehicle battery's positive
terminal, the cooling fan, and an accessory (ACC) terminal that has power
only when your vehicle's ignition is on or set to accessory (ACC).

The diagram at the end of the manual can help you understand how the system
works when it is properly installed.


(SP/RF 3/8/96)