Universal Garage Remote
(610-2107)                 Installation               Faxback Doc. # 31189

INSTALLING THE RECEIVER MODULE

You can install the receiver module at the garage door opener's open/close
switch (usually located near the door leading into the home), or at the
opener's motor box in the center of the garage ceiling.

WARNING:  While you are installing the system, keep all people, pets and
          objects clear of the garage door.

Make sure the white antenna wire is fully extended and the slide switch is
in the NO AC Adapter position, away from the receiver's 12VDC 50 MA jack.

Mounting At The Garage Door Opener's Switch

1.  Disconnect power from the garage door opener.

2.  Remove the screws holding the switch plate to the wall, and remove the
    switch plate so you can see the two terminal screws holding the wires
    that run to the motor box.

3.  Use a screwdriver to loosen the terminal screws.  Attach the receiver
    module's black and gray wires, one to each screw terminal.  Then
    tighten the screws.

4.  Reconnect power to the garage door opener.  The red LED on the receiver
    blinks once every 5 seconds.

    If the red LED does not blink, repeat Steps 2 and 33, reversing the
    black and gray wires.  If it still does not blink, see
    "Troubleshooting," Faxback Doc. # 31190.

    NOTE:  If your system has three wires (not two), you must find the
           correct two wires that make the red LED blink.

5.  Replace the switch's cover and secure it with its screws.

6.  Mount the receiver module to the wall with the supplied double-sided
    tape or the two supplied screws.

Mounting At The Garage Door Opener's Motor Box

1.  Disconnect power from the garage door opener.

2.  Use a screwdriver to loosen the two terminal screws holding the wires
    that connect the motor box to the switch.  Attach the receiver module's
    black and gray wires, one to each screw terminal.  Then tighten the
    screws.

3.  Reconnect power to the garage door opener.  The red LED on the
    receiver blinks once every 5 seconds.

    If the red LED does not blink, repeat Steps 2 and 3, reversing the
    black gray wires.  If it still does not blink, see "Troubleshooting,"
    Faxback Doc. # 31190.

    NOTE:  If your system has three wires (not two), you must find the
           correct two wires that make the red LED blink.

4.  Use the supplied double-sided tape to mount the receiver to the motor
    box.


(CS 3/6/96)