Universal Garage Remote
(610-2107)        Setting The Relay Output Style      Faxback Doc. # 31192

You can choose one of three types of relay outputs, indicated by how many
times the red LED flashes when in the programming mode described at the
end of this section:

Momentary (1 flash) - a 130 millisecond relay closure.  Use this setting
                      for normal garage door operation or for any custom
                      application.

Latching (2 flashes) - closes the relay until you push the button again.
                       Use this setting for turning on or off a lamp or
                       appliance.

Sustaining (3 flashes) - closes the relay for as long as you hold
                         down the transmitter button.

Your system is factory-set to the Momentary relay output mode for normal
garage door operation.  Follow these steps to change the output mode:

1.  Push and hold the white button on the side of the receiver for about
    5 seconds, until you see the red LED flash the number of times that
    corresponds to the desired relay output style.

2.  Release the button at the desired mode.

NOTES:  If you continue holding down the button, the receiver continues
        cycling through the modes until you release the button.

        You can change the relay output mode at any time without affecting
        the "learned" transmitter codes.

Here are examples of each output type:

Momentary:  To interface with Plug'n Power products, use a Radio Shack
            Universal Interface (Cat. No. 610-2687).

Latching:  To use the system to control a 110 VAC lamp or appliance, use 
           an external relay, such as Radio Shack Cat. No. 275-248.  Push
           the transmitter's button to turn the lamp or appliance on.  Push
           the button again to turn it off.

Sustaining:  Connect a buzzer, such as Radio Shack Cat. No. 273-060.
             The buzzer sounds for as long as you hold the transmitter's
             button down.


(CS 3/6/96)