Wireless Miniature Remote Control
(610-2618 CMC)             Operation                  Faxback Doc. # 32135

For use with the PROTECTOR PLUS Supervised Home Security System (Cat. No.
610-2611 or 610-2610).

INSTALLATION AND OPERATING INSTRUCTIONS

1.  Set Base Receiver (610-2611R) to INSTALL mode.

2.  Press CODE (on back of Remote Control) with point of a pencil.

3.  Press ARM.  Base Receiver chimes.

    NOTE:  You can install a total of eight Remote Controls by following
           steps 1 through 3.

4.  Set Base Receiver to RUN 1 or RUN 2 mode and press ARM to arm the
    system.  NOTE:  The Miniature Remote Control always arms the system
    in the "INSTANT" mode, i.e. there is no exit or entry delay.

5.  To turn on or off any Plug'N Power/X-10 module(s) set to same Housecode
    and Unit Code as Receiver, press LIGHT ON or LIGHT OFF.

6.  To trip the panic alarm instantly, press ON and OFF buttons (or ARM
    and DISARM buttons) at the same time.

7.  To replace battery:  Remove screw from back of Remote Control and 
    install A544 battery (supplied) or equivalent alkaline battery, note
    polarity.

For more detailed information, refer to owner's manual included with your
PROTECTOR PLUS Home Security System.


(CS 1/22/96)