CENTRAL 5000 Monitored Wireless Security Alarm System  
(490-2570)                 Description                Faxback Doc. # 32974

HOW THE SYSTEM WORKS

After you set up your account with ORCA Monitoring Services, your system
calls and reports alarms to ORCA Monitoring Services' trained staff of
security professionals.  See "During an Alarm" on Faxback Doc. # 19416.

The system also automatically calls ORCA Monitoring Services about once per
month to preform a routine check-in.  This call is made between Midnight
and 6 AM to avoid possible interference with other phone calls. If you lift
the handset and hear strange tones, hang up and wait a few minutes for the
call to end. If ORCA Monitoring Services does not receive a check-in within
this time, they call you to let you know of a possible problem with the
system.

ORCA Monitoring Services can also have the system blink the MONITOR
indicator and sound a chirp.  If you see this, call 1-800-FOR-ORCA to
determine the problem.

SETTING UP MONITORED SERVICE

IMPORTANT:  Your system is not fully operational until ORCA Monitoring
            Services programs the system.

To set up service, you need to:

  Fill out the enclosed monitoring agreement and mail or fax it to ORCA
  Monitoring Services.

  Install the system.

  Call ORCA Monitoring Services by lifting your phone's handset and
  pressing MONITOR on the console or by dialing 1-800-FOR-ORCA (1-800-
  367-6722) from a telephone on the same line as your system.

  During the call, ORCA Monitoring Services instructs you to press MONITOR
  on the system and then hang up the phone.  They then program option
  settings (listed on Pages 8-9) into the system.  The preferred settings
  work best for most situations.  However, you can ask ORCA Monitoring
  Services to change these settings to make the system work best for you.
  (If you do not ask for changes, the preferred settings are used.)

  NOTE:  The system beeps when programming is complete.  To avoid
         interrupting system programming, do not lift your telephone's
         handset until you hear the beep.

After ORCA Monitoring Services programs your system, you can begin using
it.  However, they do not notify emergency services of an alert until they
have received and responded to your monitoring agreement.  Allow 24 hours
for faxed requests and 5 days for mailed requests.

NOTE:  Call 1-800-FOR-ORCA at least 5 days before you move to another
       address.

Place a check mark next to any settings you want to discuss with ORCA, and
refer to these settings when you call them to set up service.

[] House Code

Preferred setting:  House Code A

Can be any House Code (A-P).
Your system can control all modules set to the same house code.

[] Flashing Alert Unit Code

Preferred setting:  Unit Code 16

Can be any Unit Code (1-16).  A light connected to a module set to the same
House and Unit Codes you select flashes when the alarm is tripped, and can
be controlled by the SECURITY LIGHT buttons on the handheld remote.  This
light also turns on at dusk and turns off around 11:30 PM when the system
is armed in the away mode.

[] Silent Alarm

Preferred setting:  Audible alarm

Can be set to only call ORCA Monitoring Services and not sound the siren
at all.  If you select silent alarm, you will hear no indication that the
system has been tripped.

[] Lived-In Look Unit Codes

Preferred setting:  2, 3, and 4

You can select any three Unit Codes.  Modules set to the same House Code
and the three Unit Codes you select turn on and off at random times after
dusk when you arm the system in the away mode.  This gives your home a
lived-in appearance.

[] Entry and Exit Delays

Preferred setting:  60-second exit delay; 30-second entry delay.

Each can be set from 0 to 1000 seconds.

[] Dial Delay

Preferred setting:  40 seconds

Can be set from 0 to 1000 seconds.  This sets how long the console waits
after it has been tripped before it calls ORCA Monitoring Services.

[] Touch-Tone Dialing

Preferred setting:  Touch-tone dialing

Can be set to use rotary dialing if you do not subscribe to touch-tone
service from your local telephone company.

[] Alarm Flash Option

Preferred setting:  Flash only the module set to the House and Flashing
Alert Unit Code you select.

You can have the system flash all light modules set to the same House Code
or flash no modules at all.

[] Panic Alarm Dial

Preferred setting:  Always call ORCA Monitoring Services when the panic
alarm is tripped.

Can be set to only call ORCA Monitoring Services if the system is armed
when the panic alarm is tripped.

[] Lights Off Time

Preferred setting:  Turn random and security lights off at 11:30 PM

Can be set to any time.  The security light turns on and lived-in lights
randomly turn on and off around dusk, then turn off at the time you select
here.

(LB/EB 5/8/96)