Central 2000 Monitored Motion Detector Security System 
(409-0351)                 System Tests               Faxback Doc. # 33273

TESTING THE SYSTEM

There are three ways to test your system:

    Testing Coverage

    Testing the Siren

    Testing the Monitoring Service

TESTING COVERAGE

Periodically test the coverage to be sure your system will detect
intruders.  To do this, disarm the system.  Then walk around the covered
area.  When the system detects your movement, the red ARMED indicator
flashes.  If the system does not sense your movement, reread "Installation"
to be sure it is properly installed.

TESTING THE SIREN

Periodically test the siren to be sure it will sound when triggered.  To do
this, lift the handset of any phone connected to the same line as the
system.  Then dial 1-800--YOUR PIN and T (8) to test.  The system waits
for the exit delay, then it sounds the siren for 3 seconds.

TESTING THE MONITORING SERVICE

Periodically have the system call the monitoring service to confirm they
are properly receiving its signals during an alert.  Before you do this,
have your password handy.  First call ORCA Monitoring Services at
1-800-FOR-ORCA to let them know you are going to test the system.  Then arm
the system, wait for the exit delay to expire, and walk through the covered
area.

ORCA Monitoring Services should call you within a few minutes of the alert.
Give them the password and advise them again that you were testing the
system.


(BR/EB 6/5/96)