Two-Zone Remote Keypad Burglar Alarm Control Center
(490-0451)                 Installation               Faxback Doc. # 33420

INSTALLING THE SYSTEM

Many sensors come with instructions to help you install them.  Follow the
instructions (if provided) with each sensor to install it in the location
you noted in your floor plan.  Then use the information in this section to
mount the alarm center and connect the sensors and other security devices
to it.

MOUNTING THE ALARM CENTER

To install the alarm center, you need four screws (not supplied) with heads
that fit into the keyhole slots on the back of the alarm center.

1.  Place the supplied template on the wall at the selected location.  Then
    mark the positions for all four mounting screws.

2.  In each marked location, drill a hole slightly smaller than the screw.

CAUTION:  Be careful not to drill into any wiring or objects behind the
          wall.  Be sure to use the proper type of screw (molly bolt or
          anchors) if you do not mount the panel to wall studs.

3.  Insert the screw into the wall, letting each head extend 3/16 inch from
    the wall.

4.  Align the keyhole slots on the back of the alarm center with the screw
    heads in the wall, then carefully push the alarm center onto the screw
    heads and slide it down.

5.  Use a flathead screwdriver to open the alarm center's door, then use a
    screwdriver to tighten the mounting screws to secure it.


(SP/EB 5/25/96)