Video DoorPhone System
(490-2600)                 Operation                  Faxback Doc. # 34179

When there is a visitor

1.  The call push button is pressed by the visitor.

    Visitor hears chime at the camera unit.

2.  Call chime sounds at the monitor unit.

    A monitor picture of the visitor appears on the monitor unit.

    If the handset is not picked up, the monitor picture will go off after
    about 30 seconds.

3.  Press handsfree button and communicate with the visitor.

    The monitor will be automatically turned off and communication will be
    cut off after about three minutes.

    If further communication is required, press the handsfree push button,
    and the system will operate for another three minutes.

    Be careful not to press the handsfree push button by mistake while
    conversation is going on, as otherwise the monitor picture will go off
    and no further communication becomes possible.

4.  Take the handset & communicate with the visitor.

5.  To activate the electric door release, press the Door Release button.

If it is desired to view the area outside your front door through the video
monitor

Press the monitor button on the Video DoorPhone

  The picture of the area outside your front door where the camera unit is
  installed will be displayed on the monitor screen.

  The monitor picture will automatically go off after about 30 seconds.

  When the handset is picked up while monitoring, you can hear sounds
  around the front door.

  The monitor picture will go off instantaneously when the monitor button
  is pressed again.

  NOTE:  Indoor sound will not be heard at outside (Camera unit).

Adjusting picture contrast                 Adjusting voice/chime volume

Slide the button left or right             The voice and chime tone can be
for better picture contrast at             adjusted from low to high volume
your viewing angle                         according to the room conditions


(LB/EB 07/25/96)