RS-500 Auto Security Alarm System  
(490-0805)                 Installation               Faxback Doc. # 34330

Follow these simple steps to install your alarm.

1.  Select a location for the alarm that is:

   Flat so the alarm's adhesive surface makes good contact

   Within 1 foot of your vehicle's battery

   Not on an engine part or any part that moves or gets hot

   Not in the way of normal engine operation or maintenance

   NOTE:  If there is space, the battery itself is usually an ideal
          location.

2.  Clip the alarm's red clip to the battery's positive (+) terminal.

3.  Clip the alarm's black clip to the battery's negative (-) terminal. The
    alarm chirps three times.

4.  Wash the surface with soap and water and allow it to dry.  Then use the
    supplied alcohol wipes to thoroughly clean the mounting surface.  Allow
    the surface to completely dry.

5.  Peel off the alarm's adhesive backing and press it onto the prepared
    surface. Hold the alarm in place for 10 seconds to help ensure a secure
    mount.

    NOTE:  If the surface is not flat, you can cut the adhesive to fit into
           surface grooves for a more secure mount.

           Straighten the alarm's yellow antenna wire and let it hang down.
           For the greatest remote control range, avoid running the yellow
           wire along metal parts.

6.  Press DISARM on the remote control.  The alarm beeps very loudly twice.
    This trains the alarm to recognize the remote.


(LB/EB 08/05/96)