Remote Control Plate  (490-0524)     Installation      Faxback Doc. # 7979

INSTALLATION PROCEDURE

1.  Find a convenient location near the entrance to the premises.  Using
    the template as a guide, drill all holes.  Then cut out the
    rectangular section as shown by the dotted lines.

2.  Mount the Key Lock Switch (shunt or momentary) on the inner plate.
    Then solder the control wires as indicated in the "Wiring" section.

3.  Using the two self-tapping screws (included), mount the Inner Plate
    assembly. using holes marked "A".

4.  Using the machine screws included, attach the face plate to the
    mounted inner plate.

Note:  The tamper switch must be used in a normally open (N.O.) circuit
       loop.

DRILLING TEMPLATE (Actual size)

HOLE DIAMETERS:

"A"     1/16 INCH
"B"     3/16 INCH
"C"     1    INCH:

WIRING:  Consult your alarm system's diagram to determine the wiring
         needed.  The example below are guides -- your system may be
         different.

Connecting Your Remote Control Plate to Burglar Alarm Center (Radio
Shack Cat. No. 49-450 or 49-450 A)

(LB/all-12/01/94)