Passive Infra-Red Alarm
(490-0308)                 Specifications             Faxback Doc. # 9617

Power Requirement:.................................120 VAC, 60 Hz, 23 Watts
                                                 (240V, 50 Hz for the units
                                                  purchased in UK/AUstralia
Power Consumption (When armed):.......................Approximately 3 Watts
Standby Batteries:.......................................8 C Alkaline Cells
                                                          (Cat. No. 23-551)
Exit Time Delay:.................................................20 Seconds
Entry Time Delay:.............................15 Seconds (may be eliminated
                                                       by removable jumper)
Automatic Reset:......................Alarm sounds for 5 minutes, shuts off
                                         and then sets itself for detection
                                                  of any further intrusion.
Coverage:
   Upper Zone (Horizontal):.......................30' (10m) Long 76 Degrees
                                                               Wide 6 Zones
   Lower Zone (Aslant):........................10' (3m) Long 56 Degree Wide
                                                 3 Zones (When the Alarm is
                                       located at 5' (1.5m) above the floor
Internal Alarm:...................85dB SPL at 10' (3m) (may be disconnected
                                         by removing internal alarm jumper)
TEST LED (Built In):................With ALARM switch in TEST position, LED
                               lights when motion occurs in detection zone.
Output Available For:
   External Alarm:........................................12VDC, 1 Amp Max.
   Alarm Relay Contact Switching Terminal Ratings:..........24 VDC 1 A Max.
                                                              130 VDC 50 mA

   Use these terminals as a switch to turn on a device such as a security
   telephone dialer that has its own power source.  It must not exceed the
   power rating above.

   Remote Switch:......................Use a shunt type key switch.  Do not
                                        use a momentary type remote switch.

NOTE:  All times are approximate.


(ALL-04/29/96)