SPDT 12V 1 Amp Relay  (275-0241)    Specifications     Faxback Doc. # 16455

Current Drain with 12V input:......................................34-36 mA
Pick-up Voltage:...................................................7.3-8.9V
Drop-out Voltage:.................................................1.8-4.16V
Coil Resistance:...............................................324-334 ohms
Coil Temperature Resistance:...........................................54.7

Contact Gap:....................................................0.15 mm Min
Contact Pressure:...........................3g Min at the center of contact
Contact Resistance:........................50 mil ohm Max by measurement of
                                         voltage drop test method (DC6V 1A)
Nominal Voltage:........................................................12V
Nominal Current:.....................................................37.5mA
Max Applicable voltage:...............................................14.4V
Operate Time (including bounce time):.....................10 mil sec Max at
                                                          nominal condition
Release Time:......................................5 mil sec Max at nominal
                                                                  condition
Dielectric Withstanding Strength
   Between Contacts:........................500VAC (50/60Hz) for one minute
   Between Coil and Contact:................500VAC (50/60Hz) for one minute
Insulation Resistance:........................100 Meg ohm at 500 VDC megger
Vibration Test:...............................................6G (10-55 Hz)
Shock Test:.............................................................10G
Coil Temperature Rise:...........................65C Max at resistance test
                                               method under nominal voltage
Contact Temperature Rise:.....................50C Max at Max contact rating
Temperature Range:........................-25C to 55C at humidity of 60% RH
                                                  Max under nominal voltage
Humidity:.........................................................95% RH Max


Specifications are typical; individual units might vary.  Specifications
are subject to change without notice.

(ALL-08/14/95)