Deluxe Computer Toolkit  (640-1990) Using the Toolkit  Faxback Doc. # 16564
with Zipper Case

TOOLKIT CONTENTS

Your toolkit contains these tools:

    IC Extractor
    IC Inserter
    Non-conductive Three-Prong Part Retriever
    Tweezers
    #1 Phillips Screwdriver
    #0 Phillips Screwdriver
    3/16" Standard Screwdriver
    1/8" Standard Screwdriver
    Screwdriver with Removable T-10/T-15 Bits
    3/16" Nutdriver
    1/4" Nutdriver
    Extra Parts Tube

Use these tools as you normally do.  The instructions below are for using
the IC Extractor, the IC Inserter, and the Three-Prong Part Retriever.

USING THE IC EXTRACTOR AND INSERTER

WARNING:  When working on ICs or other static-sensitive components, you
          should always wear a static-draining wrist strap (not supplied)
          to prevent electrostatic discharge (ESD).  Your local Radio Shack
          store sells static-draining wrist straps (Cat. No. 276-2397).

Follow these steps to use the IC extractor.

1.  Separate the extractor's arms and press them on the IC's sides until
    the two metal clips securely clamp around the chip.  The spring-loaded
    securers hold the chip to prevent it from slipping.

2.  Grip the textured portions on the extractor's arms and close them
    tightly.  Extract the IC from its socket.

    NOTE:  Grip the arms evenly so you do not bend the IC's pins.

3.  Separate the arms to release the IC.

    WARNING:  To prevent possible damage from static electricity, do not
              touch the IC with your hands.

Follow these steps to use the IC inserter.

1.  Place the inserter's arms on the IC's sides and clamp the IC tightly
    with the two arms.

    WARNING:  To prevent possible damage from static electricity, do not
              touch the IC with your hands.

2.  Move the IC above the socket and align the IC's pins with the socket's
    pin holes.  Press down until the IC securely fits into the socket.

3.  Separate the arms to release the IC.

USING THE THREE-PRONG PART RETRIEVER

Follow these steps to use the three-prong part retriever.

1.  Place the retriever above the part and press the injector on top to
    open the three prongs.

2.  Release the injector to retrieve the part.

3.  Withdraw the retriever to remove the parts.


(ALL-08/18/95)