Bayonet-type Fuse Holder
(270-0362)                  Specifications            Faxback Doc. # 19332

Operating Temperature Range:................................-20 C to + 60 C
RatingL:...............................................................15 A
Matching Fuse:..........................6.35 mm x 31.8 mm or 6.4 mm x 30 mm
Cap Cover:..................................................Molded Phenolic
Cap:........................................Brass with Nickel plated finish
Clip Spring:................................................Phosphor Bronze
Side Terminal:.......................Copper Allow with Nickel plated finish
Body:.......................................................Molded Phenolic
End Terminal:...............................Brass with Nickel plated finish
Coil Spring:.....................................................Steel Wire
Resin Washer:...................................................Polystyrene
Nut:...................................................................PA66
Contact Resistance:..................................30 milliohms max. each
                                              Measured by fall-of-potential
                                               method at 1A 2.5VDC 3 times.
Insulation Resistance:.....................................100 megohms min.
                                               500VDC is applied to between
                                                    terminals for 1 minute.
Voltage Proof:................................No insulation defect shall be
                                              observed.  1500VAC is applied
                                         to between terminals for 1 minute.
UL/CSA approved

Specifications are typical; individual units might vary.  Specifications
are subject to change without notice.


(IR/all-05/10/96)