TLC555 Timer (276-1718) Specifications Faxback Doc. # 31977 Very Low Power Consumption:............................1 mW Type at V^DD=5V Capable of Very High-Speed Operation:.......Typically 2 mHz in Astable Mode Complementary CMOS output Capable of Swinging Rail-to-Rail High Output-Current Capability:.............................Sink 100 mA Typ Source 10 mA Typ Output Fully CMOS-, TTL-, and MOS-Compatible Low Supply Current Reduces Spikes During Output Transitions High Impedance Inputs:.......................................10^12 Ohms Typ Single-Supply Operation:......................................2 to 18 volts Functionally Interchangable with the NE555; has Same Pinout FUNCTION TABLE RESET TRIGGER THRESHOLD OUTPUT DISCHARGE VOLTAGE+ VOLTAGE+ SWITCH Low Irrelevent Irrelevent Low On High < 1/3 V^DD Irrelevent High Off High > 1/3 V^DD > 2/3 V^DD Low On High > 1/3 V^DD < 2/3 V^DD As previously established. + Voltages levels shown are nominal. absolute maximum ratings over operating free-air temperature range (unless otherwise noted) Supply voltage, V^DD (see Note 1):.....................................18 V Input voltage range (any input):.............................-0.3 V to 18 V Continuous total dissipation at (or below):..........................600 mW 25 degrees C free-air temperature Operating free-air temperature range:...........0 degrees C to 70 degrees C Storage temperature range:...................-65 degrees C to 150 degrees C Lead temperature 1.6 mm (1/16 inch)from the case for 10 seconds:......................................................260 degrees C NOTES: 1. All voltage values, are with respect to network ground terminal. Electrical characteristics at 25 degrees C free-air temperature, V^DD=5 V to 15 V (unless otherwise noted) PARAMETER TEST CONDITIONS MIN TYP MAX UNIT Threshold 66.7% voltage level as a percentage of supply voltage Threshold V^DD = 5 V 10 pA current Trigger voltage level as a percentage of 33.3% supply voltage Trigger current V^DD = 5 10 pA Reset voltage 0.7 V level Reset current V^DD = 5 +/-10 pA Control voltage (open-circuit) as 66.7% a percentage of supply voltage Low-level output voltage V^DD = 15 V ^IOF = 10 mA 0.1 ^IOL = 50 MA 0.5 ^IOL = 100 mA 1 V V^DD = 5 V ^IOL = 5 mA 0.1 ^IOL = 8 mA 0.16 ^IOL = -1 mA 14.8 High-level V^DD = 15 V ^IOL = -5 mA 14 output voltage ^IOL = 10 mA 12.7 V V^DD = 5 V ^IOL = -2 mA 4 V^DD = 5 V ^IOL = -1 mA 4.5 V^DD = 15 V 360 Supply Current V^DD = 5 V 170 microA Operating Characteristics, V^DD = 5V Initial error of V^DD = 5 V to 15 V, 1% %/V timing interval Supply R^A = R^B = 1 kohm to 100 kohms. voltage C^T = 0.1 microF, sensitivity of See Figure 1 timing interval 0.1 Output pulse V^DD = 5 V. R^L = 10 Mohms, 20 rise time Output pulse C^L = 10 pF 20 ns fall time Maximum frequency in R^A = 470 Ohms, R^B = 200 Ohms, 2.1 MHz astable mode C^T = 200 pF (LB-03/23/95)