Model 160 Moviecorder  (160-0861)     Preparation      Faxback Doc. # 15134

INSTALLING/REPLACING THE CLOCK/CALENDAR BATTERY

A CR2025 lithium battery is provided with the camcorder.  This battery
powers the camcorder's clock/calendar.  Follow these steps to install or
replace this battery.

1.  Use a coin to open the battery tray lid on the bottom of the camcorder.

2.  Remove the old battery, if necessary.

3.  Install a new battery into the tray with the (+) side up as indicated
    by the marking on the tray.

4.  Insert the battery tray into the camcorder.

After you install/replace the battery, set the date and time per
instructions in "Using the Clock/Calendar."

NOTES:  The clock/calendar battery's life is approximately 1 year, but this
        can vary depending on the temperature and operating conditions.

        Do not handle this battery with any metal object.  This could
        create a short circuit that could shorten the battery's life.

INSERTING/REMOVING A CASSETTE

You can open the cassette compartment to insert/remove a cassette whenever
a power source is connected to the camcorder, whether or not the camcorder
is turned on, except when recording.

To insert a cassette, do the following:

1.  Turn the viewfinder up and press EJECT on the camcorder.  The cassette
    compartment cover automatically rises up and opens.

2.  Check the tape's window to ensure there is no slack in the tape.  If
    there is, take up the slack by turning the tape's hub with your finger.
    Then insert the tape with its window facing out and the spine facing
    up.

3.  Press PUSH on the cassette compartment door until it clicks.  The
    cassette compartment lowers and the top cover closes automatically.
    Do not force the compartment to close by pushing down the top cover or
    the tape.

To remove a cassette, press EJECT, wait for the compartment door to open,
and pull out the cassette.

CAUTIONS:  Always remove the cassette before storing the camcorder.

           If the compartment door is closed improperly, the camcorder's
           cassette-protection mechanism might eject the cassette.  If
           this happens, press the compartment side cover once again.

SETTING THE POWER SWITCH

Set the power switch to CAMERA for video recording and to VCR for playback
functions.

When setting the power switch to CAMERA or VCR, you must press and hold
the center green button.  This prevents the power from accidentally being
turned on.

VIEWFINDER ADJUSTMENT

The viewfinder eyepiece has an adjustable diopter that helps you see the
viewfinder screen clearly.

If you wear glasses, you might prefer to take them off before adjusting
the diopter to match your eyesight.

To adjust the viewfinder:

1.  Set the power switch to CAMERA.

2.  Set the standby switch to STANDBY.

3.  Pull the viewfinder up until it clicks.

4.  Turn the diopter adjustment ring until the viewfinder screen is in
    sharp focus.

ATTACHING THE SHOULDER STRAP

The shoulder strap provides a convenient way to carry the camcorder when
it is not in use.  You can also use it as a safety strap when you use the
camcorder.  Attach each end of the strap to the camcorder.

NOTE:  Do not swing the camcorder from the shoulder strap.

ATTACHING THE LENS CAP CORD

We recommend you use the lens cap cord to attach the lens cap to the
camcorder so you don't lose it.  Press the button on both sides of the
lens cap to remove it and attach cord.


(TE/all-05/05/95)