MODEL 100 4-Head (160-0618) Troubleshooting Faxback Doc. # 15696 VHS Stereo Hi-Fi VCR If the follow the instructions in this manual and still have trouble operating you VCR refer to the following troubleshooting chart. SYMPTOM POSSIBLE CAUSE CORRECTIVE ACTION No Power. The power cord is not Plug in the power connected. cord to an AC outlet. Timer recording is The problem timer is not Set the program not possible. set or set incorrectly. timer correctly. The power is on. Turn off the power. Record mode cannot be The erase-protection tab Place a piece of engaged. is missing. plastic tape over the tab hole. Picture is poor The TV channel selector On playback, set on playback. is not set to the proper TV channel channel. selector to Channel 3 or 4. The TV fine is not set Fine tune your correctly. TV. Audio/video connections Double check all are incorrect. connections. Video distortion on The video head is Have the video playback. dirty. head cleaned. The tracking is not Adjust the properly adjusted. tracking for a better picture. No picture on The TV is not set to the Set it to the playback. proper channel. correct channel (Channel 3 or 4). Audio/video connections Double check all are incorrect. connections. Operation buttons do The dew sensor is activated. Wait until the not work when the sensor is de- power is on and activated, and the cassette is then proceed with is inserted. operation. The safety device in Try to press EJECT your VCR is functioning. several times. Unplug the VCR and plug it in again after one full minute. Off-the-air TV The connections are not Recheck the programs cannot correctly made. connections. be seen. Not operation by remote The batteries are weak Replace the control. or dead. batteries. (LB/all-06/19/95)