Model 19  (160-0411)            Preparation            Faxback Doc. # 16544

CHOOSING A LOCATION

Choose a location in your home where:

    Air flows freely on all sides of the Model 19.

    The power cord is not in the way of normal traffic.

NOTE:  Do not plug in the AC cord until you have made all connections.

CONNECTING THE INDOOR ANTENNA

The supplied indoor antenna provides adequate reception in most areas, but
for best reception in all areas, use a high-quality outdoor antenna,
available at your local Radio Shack store.  See "Connecting an Outdoor
Antenna."

Follow these steps to connect the supplied indoor antenna:

1.  Insert the telescoping antenna's post into the socket on top of the
    TV/VCP's cabinet.

2.  Plug the antenna cable into the TV/VCP's ANT IN terminal.

3.  Fully extend the antenna and adjust it for the best VHF reception.

    NOTE:  To improve UHF reception, shorten the antenna.

CONNECTING THE AC CORD

Plug the supplied AC cord's smaller end into the Model 19's AC INPUT
connector.  Then plug the other end into a standard AC outlet.

WARNING:  For your protection, the power cord has a polarized plug.  To
          preserve this protection, be sure the blades fit fully and
          easily into the outlet.  If you do not have polarized outlets,
          have a qualified electrician install one before you use the
          Model 19.

NOTE:  To power the Model 19 from your vehicle's battery, see "Using
       Vehicle Battery Power."

INSTALLING THE REMOTE CONTROL'S BATTERIES

The remote control requires two AAA batteries (not included) for
operation.  For best performance, we recommend alkaline batteries (Radio
Shack Cat. No. 23-555).

Follow these steps to install the batteries.

1.  Remove the battery compartment cover by pressing the cover in the
    direction of the arrow.

2.  Place two fresh AAA batteries in the compartment as indicated by the
    polarity symbols (+ and -) marked in the compartment.

3.  Replace the battery compartment cover.

NOTE:  If the remote control does not work or operates erratically,
       replace both batteries.

CAUTION:  Use only fresh batteries of the recommended size and type.
          Always remove old or weak batteries.  They can leak chemicals
          that can damage electronic circuits.

USING THE REMOTE CONTROL

To use the remote control, point it at the TV/VCP and press the desired
button(s).

SELECTING THE ON-SCREEN DISPLAY LANGUAGE

You can set the Model 19 to display on-screen menus in English or in
Spanish.  Follow these steps to change the on-screen display language.

1.  Press POWER to turn on the Model 19.  Then, press MENU.  The menu
    display appears on the screen.

2.  Select 8 (LANGUAGE) with the remote control's number buttons or
    CHANNEL/SET TRACKING Down Arrow or Up Arrow.

3.  Press SELECT.  ENGLISH changes to SPANISH.


(br/all-08/16/95)