Color Supreme 210 Ant.  (150-1834)     Preparation      Faxback Doc. # 3395

ASSEMBLY

1.  Insert the two probes on the end of the loop antenna/reflector's mast
    into the recessed holes on the loop antenna base.

2.  Thread the telescoping antenna holders onto the adjustable antenna
    studs and hand-tighten them.

3.  Insert the threaded ends of the telescopic antenna elements into their
    holders and tighten them.

CONNECTIONS

The antenna connects to your TV or FM receiver using either the supplied
VHF and UHF 300-ohm twinlead wires or 75-ohm coaxial cable (not supplied).
The twinlead wires end in spade lugs.

Follow these steps to connect the antenna's output to your TV set
(or FM receiver).

1.  Place the antenna on top of the TV (or FM receiver) so it is close to
    the VHF terminal screws.

2.  Connect the antenna using one of the following methods:

    If your TV set (or FM receiver) has an F-connector, connect one end of
    a coaxial cable (not supplied) to the antenna's F-connector.  Then
    connect the other end to your TV set's (or FM receiver's) F-connector.

    If your TV set (or FM receiver) does not have an F-connector:

    - Connect the antenna's brown 300-ohm twinlead to your TV set's (or FM
      receiver's) VHF terminal screws.

    - Connect the antenna's gold 300-ohm twinlead to your TV set's UHF
      terminal screws.

3.  Insert the AC adapter's small barrel plug into the power input jack on
    the back of the antenna base.

4.  Plug the AC adapter module into a standard AC outlet.

    Caution:  The supplied adapter provides 6 VDC and 200 mA, its center
              tip is set to negative (-), and its barrel plug correctly
              fits the antenna's DC 6V jack.  Using an adapter that does
              not meet these requirements could damage the antenna or the
              adapter.

(br/all-12/02/94)