Model-84 VHS HQ VCR
(160-0522)            Remote Control Operation        Faxback Doc. # 31338

Most of the remote control's buttons are duplicated on the VCR's front
panel.  You can use these buttons to perform identical procedures either at
the VCR or by remote control.  The following special-function buttons
appear only on the remote control.

To use the remote control, point it at the VCR and press the desired
button(s).  

    NUMBER Buttons - allow direct selection of any channel within the
                     tuner's range.  See "How the Tuner Works."

   [TV/VCR] Button - press so that VCR appears on the display to watch the
                     signal you select using the INPUT SELECT switch. 
                     Press again so that VCR does not appear on the display
                     for normal TV viewing.

  [CH CALL] Button - press to display the current channel number the VCR's
                     tuner is tuned to.  The channel number appears on the
                     VCR display for about 4 seconds.  The channel number
                     also appears and remains on the TV screen.  To erase
                     the number from the screen, press [CH CALL] again.

INSTALLING THE REMOTE CONTROL'S BATTERIES

The remote control requires two AA batteries (not included) for operation.
 We recommend alkaline batteries, such as RadioShack Cat. No. 23-552.

Install the batteries as shown below.

1.  Remove the battery compartment cover by pressing the cover in the
    direction of the arrow.

2.  Place two fresh AA batteries in the compartment, observing the
    polarity symbols (+ and -) marked in the compartment.

3.  Replace the compartment cover.

NOTE:  If the remote control does not work or operates erratically, replace
       both batteries.

CAUTION:  Use only fresh batteries of the recommended size and type.
          Always remove old or weak batteries.  They can leak chemicals
          that can damage electronic circuits.


(RF/all-03/22/96)