TC-1010 19" TV/Monitor
(160-0260)                   Preparation              Faxback Doc. # 33496


TUNER MEMORY PROGRAMMING

When properly programmed, your TC-1010's tuner scans only selected
channels when the front panel or remote control channel selector buttons
(up arrow or down arrow) are pressed.

ADDING A CHANNEL TO MEMORY

1.  Set [TV/CATV] to the type of signals you plan to receive (out for
    normal broadcasts, in for direct cable signals).

2.  Press [MEMORY].  The MEMORY indicator lights.

    NOTE:  The MEMORY indicator comes on automatically when you first turn
           on the TC-1010 and stays on until you program at least one
           channel into memory.

3.  Press the channel up or down button or the remote control 0 through 9
    buttons to select a channel you wish to program into memory.

4.  Press [ADD].  The channel indicator blinks once.  Repeat Steps 3 and 4
    for all desired channels.

5.  Press [MEMORY].  The MEMORY indicator goes out.

ERASING A CHANNEL FROM MEMORY

1.  Press [MEMORY] so that the MEMORY indicator lights.

2.  Locate the channel you want to remove from memory by pressing the
    channel up or down button or the remote control 0-9 buttons.

3.  Press [ERASE].  The channel display blinks once.  Repeat Steps 2 and 3
    to remove additional channels.

4.  Press [MEMORY].  The MEMORY indicator goes out.


(IR-06/20/96)