Portable TV  (160-0121)          Operation             Faxback Doc. # 7799

To operate your TV:

Turn on the TV by moving the VOLUME dial up until it clicks.

Adjust the volume by moving the VOLUME dial up or down.

Select the channel as follows:

1.  Set the TV band switch to the desired band.

    The following chart shows the band switch settings and available
    channels for each band.

            ┌─────────────────┬──────────────────┐
            │      Band       │    Available     │
            │                 │    Channels      │
            ├─────────────────┼──────────────────┤
            │  VHF-LOW        │        2-6       │
            ├─────────────────┼──────────────────┤
            │  VHF-HIGH       │        7-13      │
            ├─────────────────┼──────────────────┤
            │  UHF            │       14-69      │
            └─────────────────┴──────────────────┘

2.  Move the TV TUNING dial until the dial indicator points to the desired
    channel.  Then, fine tune for the best reception.

Improve the picture quality by adjusting the following controls on the back
of the TV.

    To adjust the brightness of the picture, rotate the BRIGHT control.

    To adjust the difference between the light and dark areas of the
    picture, rotate the CONTRAST control.

    If the picture rolls, rotate the V-HOLD control until the picture
    stops rolling.

To change the viewing angle, for table top viewing, position the support
bar under the TV.

To listen in privacy, plug mono earphones or headphones with a 1/8-inch
plug into the HEADPHONE jack on the back of the TV.

NOTE:  The internal speaker is disconnected when you use the HEADPHONE
       jack.

(ALL-10/10/94)